PENTENS T-007 is acrylic emulsion which is a excellent bonding adhesion/primer and a excellent modifier of cement to improve the chemical, corrosion, moisture and salt resistance of cement renders.

USES

- Bonding Adhesion/Primer of water-based waterproofing/flooring/painting works

- Mix with mortar to repair and resurface of factory floors drive ways, angle fillets

- New and old concrete bonding agent

- Multi-purpose adhesive

Physical Data

Appearance : Liquid(Milky)

Form : Acrylic Resin Water

Density : 1.0

Solid Content : >46%

Waterproofing Primer : Pentens T-007 - 1kg

                                         Water - 3kg

Slurry Coating : Pentens T-007 - 1kg

                            Water - 8kg

Storage condition : Store in dry cool place

APPLICATION

Surface Preparation

All the surfaces must be clean, free from grease, oil, laitance, and remove all the dirt and contaminants, which might affect adhesion. The impurity outside the structure body should be cleaned thoroughly.

Application

Substrate should be primed with a 1:3 mixture of PENTENS T-007 and water.

Brush on at the approximate rate of 0.3 kg/m. Allow to become tacky then apply topping. For porous surfaces prime with a slurry coat (refer Specifications for mix recommendation).

SAFETY

Impervious gloves and barrier cream should be used when handling these products.

Eye protection should be worn. In case of contact with eyes, wash thoroughly with plenty of water and seek medical advice if symptoms persist.

If contact with skin occurs, it must be removed before curing takes place.

Wash off with an industrial skin clearer followed by plenty of soap and water. Do not use solvent.

Ensure adequate ventilation when using these products.

Pentens T-007 & ECO 007 is better to use for Pentens T-100 / T-200 / T-200h Primer